Tools required: welding torch, hook knife, pressing wheel, tape measure, scraper and cork.
clean the site, keep leveling, ensure that the bottom of the pool, the wall cement bright surface, no sand, dry.
According to the venue to make the swimming pool waterproof film laying method, and then arrange the material;
After the material is arranged, the overall glue should be evenly distributed.
Then paste the waterproof film on the swimming pool, and weld the swimming pool waterproof adhesive film at the width of at least 5cm.
Edge treatment is adopted according to different structural locations.
Check the location of welding after finishing the inspection and revise it if the welding is not in place.
After the waterproof adhesive film is completed, it is necessary to dry up to 48h and water injection.
waterproof adhesive film is elastic polyvinyl chloride PVC material, strictly prohibit sharp cuts, such as scissors, angle iron, etc.
No clean tools such as steel wire ball can be used for cleaning the plastic film pool.
The bottom of the tank is cleaned with a hard brush and a small amount of detergent.
In winter, for better protection of plastic film, preventing weathering and life expectancy, water injection at the bottom of the pool can be adopted (water injection volume is full over the bottom of the tank).
The use of disinfectant or disinfectant tablets should be diluted in advance and then sprinkled to the pool surface in advance.